heating curve

英 [ˈhiːtɪŋ kɜːv] 美 [ˈhiːtɪŋ kɜːrv]

升温曲线;加热曲线

电力



双语例句

  1. The consumption characteristics for heating generating units is based on the economic dispatching, but the characteristic curve of the steam consumption of an extraction is complicated and its application is weaker.
    供热发电机组的耗量特性是经济调度的基础,但供热汽轮机的工况图比较复杂,其实用性较差。
  2. The optimum heating up curve, constant temperature, and cooling down system should be worked out as per different raw materials, production process and season.
    要根据原料、生产工艺和季节的不同制订相应的最佳升温、恒温及降温制度。
  3. X-ray tube assembly heating curve
    X射线管组件发热曲线
  4. A New Method for Assessing the Thermal Stability of Polymers via Single Heating Rate TGA Curve
    由单TGA曲线评价聚合物热性能的新方法
  5. On heating pocess, the differential thermal analysis curve showed a peak at about 800 ℃., corresponding to the formation of DQC from its approximants.
    加热过程的差热分析曲线表明,800℃附近存在一个吸热峰,这对应着晶体相向十重准晶的转变。
  6. Owing to the existence of the latent heat, there will be an inflection on the heating curve, resulting in the formation of a step.
    由于相变潜热的存在,当加热电流适当大时,会使升温曲线产生拐点而形成台阶。
  7. The correct heating methods and the curve of air temperature change at outlets of MS adsorbers and the other problems needing attention in heating operation are described.
    并介绍了正确的加温方法,分子筛吸附器出口空气温度变化曲线和加温中需注意的其它问题。
  8. There is a cold crystallization peak for the quenching sample in heating DSC curve, and there is not for the others.
    在DSC曲线中淬火样品有冷结晶峰,而其它样品没有。
  9. D and Z-value comparison between microwave heating and water bath sterilization while altering the microwave heating curve and employing program simulation
    利用程序模拟水浴升温比较微波加热与水浴杀菌的D值和Z值
  10. As the heating rate increases, the curve of DTG shifts to high temperature, and the activated energy and frequency factor decrease, which provides a basis for preparing activated carbon in fast-pyrolysis way.
    随升温速率的上升,DTG曲线向高温区移动,反应表观活化能和频率因子呈减小趋势,为快速热解制备活性炭提供理论依据。
  11. The result shows that a optimum strip ( SPCC steel) heating curve and a furnace temperature curve be gained.
    结果获得了SPCC钢优化的带钢升温曲线和炉温曲线;
  12. It was revealed by the experiment that the heating curve control affected the conversion rate largely, therefore it must be standardized and unified.
    试验表明,升温曲线控制对转化率的影响较大,必须规范和统一。
  13. The paper has established the mathematical model of FUT, and has carried it on the water power operating mode simulation in the laboratory bench, and has drawn up the heating movement regulating curve.
    本论文对质调节下量调节供暖调节方法建立了数学模型,并在实验台上进行了水力工况的模拟,绘制了供暖运行调节曲线;
  14. In the temperature span of the endothermic peak of the DSC heating curve, the average transformation rate is relatively large.
    在复合材料DSC加热曲线上吸热峰所在的逆相变温度区间内,马氏体逆相变的平均速率较大;
  15. The practical heating up curve was agreed with the planned drying-out curve.
    实际升温曲线与计划烘炉曲线保持一致。
  16. The heating curve method was adopted to study the SCC strategies for normal and typical strong dynamic operation of furnace, as a result, the optimal control algorithm suitable for the furnace was obtained.
    以实际的连续加热炉为研究对象,采用加热曲线法较全面地研究了炉子一般动态和典型大幅度动态操作时的SCC决策,得出了适于在线应用的优化控制策略。
  17. Heating Curve and Control for Multi-Oven Heating Die
    多腔室模具加热曲线及控制
  18. In the end, a perfect protective method put forward, which has both direct and indirect temperature protection features, by heating limit curve.
    最后,提出了一种利用发热限制曲线及计算机使其具有直接与间接温度保护的较为理想的保护方法。
  19. On the basis of ignition heating up curve, the ignition procedure is divided into three stages-heating, firing and burning.
    根据点火曲线,可将其分为加热、着火和燃烧三个阶段。
  20. The SCC strategies under common dynamic operation and representative operation by a wide margin are useful for application on-line, studied in many aspects by heating curve method.
    用加热曲线法较全面研究了炉子一般动态和典型大幅度动态操作时的SCC决策,有利于其在线应用。
  21. Analyzing the reasons of semi-steel cold ingots crack occurred in heating and theoretically calculating heating speeds of semi-steel cold ingots, a practical curve of heating process is worked out.
    通过分析半钢冷锭加热裂纹产生原因,以及对半钢冷锭加热速度进行理论计算,制订了切实可行的加热工艺曲线。
  22. Since this sub-model is embedded in the current automatic combustion control model, it is easy to adjust the optimal heating curve of slabs according to current state of slabs and furnace from time to time such that the setpoints of furnace temperature are always optimal.
    由于模糊系统嵌在自动燃烧控制模型内部,因此在每个周期计算中都会根据当前板坯的情况来动态修改最佳升温曲线,从而使加热炉的设定炉温始终处于优化状态。
  23. Effect of partial scanning, partial scanning and annealing, heating rate, cooling rate and successive annealing at lower temperature on the melting curve was studied.
    研究了部分扫描,部分扫描再退火,加热速率,冷却速率,依次降温退火对熔化曲线的影响。
  24. Adaption of Ideal Heating Curve to Mill Temperature
    理想加热曲线对轧线温度的自适应
  25. Meanwhile, the J × B heating mechanism with the density profile modification is discussed, and the relation curve of the corresponding absorption coefficient vis the laser intensity is obtained.
    探讨了密度轮廓修正下的J×B加热机理,给出了相应的吸收系数随激光场强度变化的关系曲线。
  26. Through experiments, drawn different evaporation temperature heating water temperature curve, curve and thermal heat pump heat pump COP curve, then analysis the heat pump operating conditions. 3.
    通过实验,绘出不同蒸发温度下加热水箱的温度变化曲线、热泵制热量变化曲线与热泵COP变化曲线,进而对热泵的运行工况做出分析。
  27. It is obtained the analysis of the variation law of heating network thermal condition caused by the change of heating users condition when the operation of heating network under the regulation curve drafted.
    分析热网在拟定调节曲线下运行时,由于热用户工况变化而引起的热网热力工况的改变。
  28. The spot welding temperature field is calculated based on the ANSYS heat and electrical element; we received the heating characteristic and the thermal cycle curve of resistance spot welding.
    基于ANSYS的热电单元计算了电阻点焊温度场,得到电阻点焊加热的特点和点焊热循环曲线。
  29. Enterprises in order to cope with the fierce market competition, to achieve higher product quality often need according to the heating parts of the specifications and varieties change furnace temperature even in a temperature curve of strict control of furnace temperature.
    企业为了应对激烈的市场竞争,获得更高的产品质量经常需要根据加热零部件的规格及品种改变炉内操作温度甚至需要按照一定的升温曲线严格控制炉内温度。